Free roof inspection with deck photos before we talk money - GAF and Owens Corning certified installation
Fast, Reliable Roofing Company Across Tequesta
Tequesta roofs fail differently than roofs ten miles inland. Salt air from the Atlantic, the Intracoastal, and the Loxahatchee River hits your roof from three directions at once, eating through standard fasteners and flashing years before the shingles show wear. Tilehurst Roofing is the local Roofing Company built for this exact problem. We spec coastal-grade hardware, put every price in writing before work starts, and answer the phone when you call. Need a roofer in Tequesta today? Call (945) 303-9821 for a free estimate.
Why Tilehurst Roofing Is Tequesta’s Preferred Roofing Company
Tequesta homeowners keep telling us the same story: a crew showed up late, changed the price at the door, or finished a repair that failed within months. Greg Holloway built Tilehurst Roofing to end that cycle. Our technicians are background-checked and uniformed, so you know exactly who is on your roof. Every job starts with a written price in your hands before a single nail is driven. And every repair carries a written guarantee delivered before the crew leaves your driveway, not mailed later.
We answer the phone live, 24/7. No voicemail, no callback queue. When a Tequesta homeowner calls about a leaking valley or a rusted drip edge, they talk to a person who can schedule the visit right then. Our crews serve Tequesta neighborhoods including Riverside Drive, Tequesta Country Club, and the waterfront estates along the Intracoastal. Dispatch and scheduling are coordinated from our South Florida office in Miami; the crews work locally in Tequesta every week.
Material choice matters here more than most roofers admit. We offer products from seven manufacturers: GAF, CertainTeed, Owens Corning, IKO, Atlas, Tamko, and Boral. That means the product fits your home and its exposure, not just what happens to be on the truck.
Commercial Roofing in Tequesta
Commercial Roofing in Tequesta means low-slope or flat systems on small professional buildings, waterfront condos, and the retail and office spaces clustered along U.S. Highway 1 and Tequesta Drive. Flat commercial roofs in this village sit in a high-wind coastal exposure zone, so the roof assembly has to meet Florida Product Approval standards for uplift resistance while also handling standing water after summer downpours. A commercial re-roof in Tequesta typically runs $9-$14 per square foot installed, depending on membrane type, insulation depth, and whether the existing deck passes inspection or needs replacement. The salt air problem is worse on flat roofs because standing water concentrates salt residue at seams and drains.
Membrane Selection for Coastal Flat Roofs
We typically recommend TPO or PVC membrane for Tequesta commercial buildings. PVC holds up better against the salt and chemical exposure near the water, but TPO costs less upfront. Either way, the seams are the weak point, and we specify hot-air welded seams rather than adhesive because salt accelerates adhesive breakdown within three to five years.
When a Tequesta Business Should Replace Instead of Repair
If your commercial roof has multiple patches, visible seam separation, or rusted edge metal, a patch is buying time, not fixing the problem. A building owner in Tequesta spends more per square foot on repeated repairs over five years than on one properly installed replacement. Call (945) 303-9821 and we will walk the roof with you and give you a written line-item quote before you decide anything.
Metal Roof Installation in Tequesta
Metal Roof Installation in Tequesta is one of the smartest moves a homeowner can make, and one of the most misquoted. Standing seam metal roofs in Tequesta run $14-$22 per square foot installed. That is more than architectural asphalt shingles at $6-$9 per square foot, but the metal roof will likely outlast two shingle roofs in this climate if it is installed with the right fasteners and underlayment. Florida Product Approval-rated metal panels, Type 316 stainless fasteners, and a properly ventilated deck are not optional here. They are the difference between a roof that lasts 50 years and one that starts corroding at the screw heads in eight.
Coastal-Spec Metal Panels
Standard Galvalume panels will corrode faster in Tequesta than in Jupiter Farms or Palm Beach Gardens, purely because of the three-sided salt exposure. We specify PVDF-coated aluminum or Galvalume with a marine-grade finish for homes within a half mile of the Intracoastal or the river. The finish matters as much as the metal underneath. A cheap painted panel shows chalk and rust streaks within a decade near the water.
Fasteners and Deck Prep
On a Tequesta metal roof, the fasteners get more attention than the panels. We use Type 316 stainless or hot-dip galvanized fasteners on every coastal-spec job, and we re-nail the existing deck to current code before the underlayment goes down if the home predates the 1994 code. That re-nail adds cost and a day to the timeline, but skipping it means attaching a 50-year roof to a deck that is already loosening.
Trusted Brands We Service in Tequesta
Tequesta homeowners deserve a genuine choice in roofing materials, not a single house brand. Tilehurst Roofing installs and services systems from GAF, CertainTeed, Owens Corning, IKO, Atlas, Tamko, and Boral. When you call us for a repair or replacement, we match the product to your home’s exposure, pitch, and structural condition. We also stock common GAF and Owens Corning shingle colors and flashing profiles locally for Tequesta customers, which means faster turnaround on matching repairs and fewer days waiting on a distributor to ship the right bundle. Call (945) 303-9821 and we will tell you what your existing roof needs before we ever show up.
Common Roofing Company Problems We See in Tequesta Homes
- Rusted deck fasteners on pre-1994 homes. Many original Tequesta ranch houses from the 1960s and 1970s have roof decks fastened with 6d nails on wide spacing. When we open the deck for a re-roof, the nails are often rusted at the penetration points, and the permit inspection requires a full re-nail.
- Corroded drip edge and ridge vents. Standard aluminum drip edge thins out quickly under Tequesta’s salt air, especially on Riverside Drive and Intracoastal-fronting homes. We replace it with pre-finished aluminum rated for coastal exposure or stainless where the home sits right on the water.
- Roof-to-wall flashing failures at CBS block construction. Concrete block homes from Tequesta’s original buildout shift slightly over time. The flashing at the roof-to-wall junction pulls loose, and water gets behind the stucco. We see this constantly on low-slope 4:12-pitch ranch roofs.
- Underlayment rot under tile roofs. Clay and concrete tile roofs look great from the street, but the underlayment beneath them degrades after 20 to 25 years in this climate. The tile outlasts the waterproofing underneath, and homeowners only find out when water starts staining the ceiling.
Pricing for Roofing Company in Tequesta, FL
An architectural asphalt shingle roof in Tequesta runs $6-$9 per square foot fully installed, including tear-off, deck inspection, and code-required re-nailing on older homes. Clay or concrete tile replacement runs $12-$18 per square foot, and standing seam metal runs $14-$22. Standard repairs like a rusted flashing replacement or a small leak fix run $350-$900. The coastal-spec version of any job costs roughly 10-18% more than the inland-spec version because of upgraded fasteners and flashing. That extra money buys a roof that does not need to be torn off in eight years. Call (945) 303-9821 for a free written estimate on your Tequesta roof.
We Also Serve Cities Near Tequesta
Tilehurst Roofing serves Tequesta and the surrounding South Florida communities, including Miami, Hialeah, Fort Lauderdale, and Pembroke Pines. If you are in Tequesta or a neighboring town and you need a roofer who puts the price in writing before work starts, call (945) 303-9821.
Serving Tequesta, FL - Our Local Coverage Area
We’re based in the Tequesta area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Roofing Company in Tequesta
Homes built before the 1994 Florida Building Code often have roof decks fastened with 6d nails spaced too far apart to meet current high-wind-zone requirements for Tequesta’s coastal exposure category. When we open the deck for a permit inspection, the inspector requires a full re-nail to bring the fastener spacing up to code before the new system goes on. It adds cost and a day, but it is not optional, and any roofer who skips it is leaving you with a roof attached to deteriorated framing. Call (945) 303-9821 and we will tell you upfront whether your home is likely to need the re-nail.
We specify Type 316 stainless or hot-dip galvanized fasteners on every Tequesta coastal-spec job, and we use pre-finished aluminum or stainless for drip edge, ridge vents, and flashing. Standard electroplated or standard-galvanized fasteners rust through in five to eight years under Tequesta’s three-sided salt exposure. The upgraded hardware costs a little more per sheet or per nail, but it is the single biggest factor in whether your roof lasts one decade or three.
A coastal-spec roof in Tequesta runs about 10-18% more than the same job spec’d for an inland town. On an average 2,000-square-foot asphalt shingle roof, that is roughly $1,200-$2,500 in additional material and labor for upgraded fasteners, marine-grade flashing, and a self-adhered membrane in the valleys. The cheap spec saves money today and costs a full re-roof within a decade. Call (945) 303-9821 for a written quote that shows both spec levels side by side.
Yes, when they are installed to Florida Product Approval standards with the right panel profile, fasteners, and deck prep. A standing seam metal roof is one of the best-performing systems in a high-wind coastal zone because the panels interlock and the concealed fasteners are protected from salt spray. The catch is the underlayment and deck work. A metal roof on a pre-1994 Tequesta home still needs the full deck re-nail before installation.
One square is 100 square feet of roof area, and it is the unit every Tequesta roofing quote should use. Compare bids by looking at the total squares, the material listed, the fastener spec, and whether deck re-nailing is priced in or left as a change order. The honest quote shows the re-nail, the upgraded flashing, and the underlayment type as line items. Call (945) 303-9821 and we will send you a written quote with everything priced before you sign anything.
Tequesta roofing decisions come down to one thing: materials that survive salt air, installed by a crew that shows up and stands behind the work. We re-roofed a 1968 CBS ranch off Riverside Drive where the original 6d-nail decking had rusted through at the penetrations and the drip edge was paper-thin from salt air. The homeowner had two bids using electroplated fasteners and standard underlayment; we spec’d hot-dip galvanized nails, a self-adhered ice and water shield in the valleys, and a stainless ridge vent, then added a full re-nail to current code before laying architectural shingles. The deck passed inspection and the new system is rated for the high-wind zone, but the real win is that the next owner won’t be re-roofing again in eight years. That is the whole point. Call (945) 303-9821 for your free estimate, and we will put the coastal-spec numbers in writing before any work starts.
Written by Greg Holloway, Owner at Tilehurst Roofing, a Kingswell family roofing company founded in 2000.






Before
After
Before
After
Before
After